90+ Fine Woodworking Magazine Back Issues ~ My Wood Blog

Happy emoji with i am fine concept, flat sticker

in.pinterest.com

```html

DIY Fine Woodworking Magazine Holder: A Step-by-Step Guide This guide will walk you through creating a stylish and functional magazine holder from wood, perfect for displaying your collection of "Fine Woodworking" magazines or any other periodicals. The project is designed to be achievable for intermediate woodworkers.

Materials and Tools You'll Need

Wood: Select a hardwood like cherry, walnut, or maple. You'll need enough for the sides, bottom, and dividers. Dimensions will depend on the size of your magazines and desired holder capacity, but plan for around 1/2" to 3/4" thickness for good stability. A common size might be roughly 12" wide, 10" deep, and 12" tall. Adjust measurements based on the number of magazines you wish to store.

Wood Glue: High-quality wood glue is essential for strong joints.

Clamps: Various sizes of clamps to hold the pieces together while the glue dries. Pipe clamps and bar clamps are useful.

Saw: A table saw or circular saw for cutting the wood to size. A miter saw is helpful for accurate angle cuts.

Router (Optional): A router with decorative bits can add a refined edge to the sides.

Sander: A random orbital sander with various grits (80, 120, 220) for smoothing the wood.

Measuring Tape and Square: Accurate measurements are critical.

Drill/Driver: For pre-drilling screw holes (optional, for extra reinforcement).

Screws (Optional): If using screws, select appropriately sized wood screws.

Finish: Choose your desired finish varnish, lacquer, oil, or wax.

Safety Glasses and Hearing Protection: Always prioritize safety.

Step 1: Cut the Wood to Size Carefully measure and cut all the pieces to the required dimensions. Ensure the cuts are square and accurate. This is crucial for a well-constructed magazine holder. The specific dimensions depend on the number of magazines you want to store and the desired aesthetic. Typically, you'll have two side pieces, a bottom piece, and potentially one or more divider pieces. A back piece can be added for increased structural support.

Step 2: Assemble the Sides and Bottom Apply wood glue to the edges of the bottom piece and the inside edges of the side pieces. Clamp the pieces together tightly, ensuring they are square. Use a square to confirm the corners are at 90 degrees. Wipe away any excess glue with a damp cloth. If desired, pre-drill pilot holes and add screws for extra strength. Allow the glue to dry completely (usually 24 hours).

Step 3: Add Dividers (Optional) If you want to divide the magazine holder into sections, measure and cut divider pieces to fit snugly between the sides. Apply glue to the edges of the dividers and position them within the holder, ensuring they are square and evenly spaced. Clamp the dividers in place and allow the glue to dry completely.

Step 4: Sanding and Finishing Once the glue is completely dry, remove the clamps. Sand all surfaces with progressively finer grits of sandpaper (80, 120, 220) until smooth. Pay close attention to the edges and corners. If desired, use a router with a decorative bit to round over or profile the edges. After sanding, remove all dust with a tack cloth. Apply your chosen finish according to the manufacturer's instructions. Allow the finish to dry completely between coats, and lightly sand with fine-grit sandpaper (400 grit) between coats for a smoother surface.

Step 5: Final Touches Inspect the finished magazine holder for any imperfections. Add felt pads to the bottom to protect your furniture from scratches. Load up your "Fine Woodworking" magazines and enjoy your hand-crafted creation!

Conclusion You've successfully built a beautiful and functional magazine holder. This project allows for customization in terms of wood selection, dimensions, and finish, making it a rewarding woodworking endeavor. With patience and attention to detail, you can create a piece that will proudly display your collection for years to come.

```